What is the reason for the sloping plate on the filter plate of the filter press?

Abstract: This situation occurs in the filter press; there are mainly the following reasons: 1. When the filter press is unloaded each time, the material under the filter plate is not completely cleaned; therefore, when the filter press is compressed, the overall On the sloping plate site, a long time will cause the deformation and displacement of the rack.

There are several reasons for this situation in the filter press:

1. When the filter press is unloaded each time, the material under the filter plate is not completely cleaned; therefore, when the filter press is compressed, the overall inclined plate scene occurs, and the frame will be deformed and displaced for a long time.

2. The handle of the filter plate works for a long time, and the wear-resistant block or pulley of the handle on the side of the filter plate 2 has different degrees of loss, which will also cause this phenomenon.

3. The design of the filter press is defective, and this problem exists when it leaves the factory, so that it becomes more and more obvious.

4. The installation height of the handle of the filter plate is not accurate and is not controlled within the normal error range.